Service Installation using FatClient Installation Route
FatClient Route for Authentication
You have decided to load the service using the FatClient authentication route. The following DBProxy screen appears.
The first time installation default entry 'I have a single database User ID and Password for ALL connections', is pre-selected. This means that a single DB User and password has been setup for all connections and is designed to make password change control easier. If available from your Systems Manager enter details and select Next to display the Port setting default screen.
If the second radio button 'I DO NOT have a single database User and Password for ALL connections' is selected, the User ID and Password entry boxes are greyed out and the system uses the F98OWSEC table. No single entry is possible. Select Next to continue and the final database password screen appears.
If this is not the first installation then the default entry here is the same as your 'last time' selection. In this case the second option was taken last time and is now the default.
Enter the necessary passwords against the DB User ID's listed.
On selecting Next the jdeDirect Gateway Advanced Settings screen displays the default TCP/IP port.
On entry the TCP/IP Port will be greyed out but displays the default port id. If for any reason you wish to change this Port ID then select the Use Default check box and entry will be allowed in the TCP/IP Port field.
On 'Next' the successful installation completion wizard appears.
